Skyjacker JC4558KSMLT 4.5 Inch Suspension Lift System Skyjacker JC4558KSMLT

Softride(R) springs use only American steel and the individual leafs of each spring are shot-peened with hard steel pellets at very high velocities. This shot-peening compresses the surface of the steel thereby increasing the tensile strength of the spring. Without this shot-peening procedure, the maximum wheel travel and ride quality could not be achieved without sacrificing the life of the spring. Softride(R) springs use bolt style spring clips, eliminating friction. Other spring designs use the c in. style bend clips which bend tightly over the spring leafs causing binding and friction. Skyjacker(R) Softride(R) springs taper over the entire length of the leaf creating more flex at the leaf ends. This tapering distributes loads more evenly over a greater area and reduces the tendency for one leaf to dig into the leaf above it. Rear Softride(R) springs are used to complete the SYSTEM in a Skyjacker(R) suspension lift.

Specifications:

Lift/Drop Height	4.5 in.
WARNING CA Proposition 65	Yes
WARNING CA Proposition 65 Message	California Residents- WARNING: Cancer and-or other Reproductive Harm. (For more information go to www.p65warnings.ca.gov)
Description_DES	4.5 Inch Suspension Lift System
Description_EXT	4.5in. LT/DR 84-01 XJ;4MONO
Description_FAB	Other Parts Required For A Complete Set
Description_FAB	Load Capacity Will Be Equal or Greater Than OE
Description_FAB	Made With American Steel
Description_FAB	Constructed As Progressive Multileaf Packs
Description_FAB	Limited Lifetime Warranty
Description_INV	4.5in. LT/DR 84-01 XJ;4MONO
Description_MKT	Softride(R) springs use only American steel and the individual leafs of each spring are shot-peened with hard steel pellets at very high velocities. This shot-peening compresses the surface of the steel thereby increasing the tensile strength of the spring. Without this shot-peening procedure, the maximum wheel travel and ride quality could not be achieved without sacrificing the life of the spring. Softride(R) springs use bolt style spring clips, eliminating friction. Other spring designs use the c in. style bend clips which bend tightly over the spring leafs causing binding and friction. Skyjacker(R) Softride(R) springs taper over the entire length of the leaf creating more flex at the leaf ends. This tapering distributes loads more evenly over a greater area and reduces the tendency for one leaf to dig into the leaf above it. Rear Softride(R) springs are used to complete the SYSTEM in a Skyjacker(R) suspension lift.
Description_SHO	4.5 In Lift System